Hello all welcome to a new video on my channel. Today we will be doing something different! We are going to forge with Johan. We will start with a round rod of steal and make a leaf out of it. 1st we are going to make a small point at the beginning of the rod. So you will need to hit the beginning of the material. We make it square 1st and than pointy like so. Next, when you use the peen of the hammer and hit it here, than you will see that it gets wider. You will push the metal down with the hammer below that we will make it thinner again. And it will end up looking like a leaf. So by molding the steel when it’s hot we can make a leaf like so! Whats that noise? That is Air… Air contains oxygen causing the fire to burn really nice and hot! With this valve I can adjust the airflow. Look. Now the air is off, causing the coals to burn less. And now the air is on again, causing to burn more and hotter! We will be using the hottest part of the fire to melt the steel. When the steel is orange it’s hot enough! It’s bouncing back! Look! I’m going to use the peen of the hammer to start shaping the leaf. Lets go. The main shape of the leaf has been done. Next the leaf’s stalk! 1st we need to make it square… .. than we make it thin, and than round! Now we are going to make the stalk round, and than we will cut it! After this I need to hold it with some pliers! This will be the hardest part! We are going to cut it now! Look. By doing this it will come off easily. Be Careful.. It’s very hot! This the leaf. Now I’m going to give it a bit more of a shape! This is so hard to do! Finally. Rounding the stalk! Keep hitting it. Looking good! So cool! Well. That’s it for this video. It looks nice. That’s what I think, and I hope you guys like it too! Nothing more to say. See you next Sunday in a new video!