Hello! Olga is with you. You are on the Best NEEDLEWORK channel. Today I’ll show you how to make a big chic bow. I will need two ribbons 4 cm wide, 65 cm long. One is colored, the other is plain. I will work simultaneously with two tapes. Fold the ribbons in half. Burning the fold line. I unfold. Now I need to make a figure of eight tapes. I outline the middle of the edge of the tape and combine it with the fold line. Glue using Titanium glue. You may have another silicone glue. I also glue the other edge of the tapes. I glue all four layers. I turn the figure eight horizontally and fold in half. I bend the fold lines. Next, I take a monophonic tape 4 cm wide, 25 cm long. I glue her ends. It turned out a ring. I fold it in half and outline the fold lines. I put the figure eight into the ring, combining all the fold lines. Then I apply the edges of the figure eight to these lines. I fix with clamps. I turn the bow blank and press the monophonic ribbon to the center. I take a needle with a thread and along the fold line I sew all the ribbons together. I’m pulling the thread. I wrap a bow around the center several times, tie a knot and trim the ends. I’m putting off the bow. Next, I take a monophonic tape 4 cm wide, 20 cm long. Fold in half. I burn the fold line. I unfold. I add the edges of the tape to the fold line of the overlap. I use the clamp. I’m stitching. I pull the thread. I wrap around the center of the bow and fasten with a few stitches. Now I glue both bows with each other with hot glue. On the reverse side I gum the rubber band. I take a narrow colored strip of ribbon and stick it around the middle of the bow. Here I got such a bow. Making such a bow with your own hands is simple, but it looks gorgeous. If you liked the video, like and subscribe to my channel! Olga was with you!