Hello everybody! You are on the Best NEEDLEWORK channel. Today I will show how to make a big beautiful bow from rep ribbon. I take a tape with a picture on one side. The second side is plain. 4 cm wide, 46 cm long. Fold in half. Outline the middle. From myself I add the edges of the tape “house”. I fix the top of the “house”. I use a clamp for this. I bend the right edge of the tape diagonally to the right and bend the resulting triangle to the left. With the left end of the tape I do the same, but in mirror image. This is how it should turn out. Then I turn over the workpiece. Pay attention to the distance between the top of the “house” and the ribbons. I fold the edges of the tape diagonally down on top of each other. Then I bend up to the corner of the intersection of ribbons. See how it should turn out. While holding the entire workpiece, I trim the corner protruding from the tape. I burn the edge. I fix it with a clamp. I need two such blanks. Sew the edges of the blanks sequentially. I tighten the thread, tie a knot, cut off the ends. I take a hair clip – a clip 7.5 cm long. I scratch its surface for better adhesion. I put hot glue on it and glue a small strip of felt. I’ll stick the resulting bow to it. Next, I take a piece of the same ribbon from which I made a bow 6 cm long. I fold its edge with an accordion with a shift down, I burn the edge. I fold the second edge with an offset up, burn. The middle turned out to be voluminous. From the inside, glue one edge of the workpiece with glue and glue it in the center of the bow, starting under the clip of the barrette. The second edge is also glued to the hairpin. Look, what a beautiful bow it turned out! He will decorate your daughter’s hairstyle! Like and share videos with friends! Subscribe to my channel! Olga was with you!